| |
- LIMTED EDITION - NOW DISCONTINUED
- Copper / brass construction
with turn coat shrouds.
- 3/8"BSPT inserts to
allow the radiator to be used with any existing
bore setup. e.g. 3/8"OD & ID, 1/2"OD
& ID etc.
- Unique dual fan shroud gives
total air seal even between the fans!!, no
loss air as with other designs.
- Pre-punched shroud holes
for perfect hole alignment!
- Radiator can run up to 4
x 92mm fans in push / pull config or one side
of shroud can be used for mounting.
- 13mm shroud standoff to
minimise dead zone.
- Unique silver soldered bleed
inserts for bleeding off collected air &
maintaining performance.
- Radiatior ships with single
side fan screws & a spare bleed washer.
- Capable of dissipating APPROXIMATELY
285W of heat at a 10°C coolant / air differential,
more if differential is increased.
- APPROXIMATELY 0.045°C/W
|
HE120.1
// HE120.2 // HE120.3
// HE80.1 // HE80.2
// HE90.1 // ThermoTube
// PA160 // PS120.x
|
