| |
DISCONTINUED
- Copper / brass construction
with turn coat shrouds.
- 3/8"BSPT inserts to
allow the radiator to be used with any existing
bore setup. e.g. 3/8"OD & ID, 1/2"OD
& ID etc.
- Unique dual fan shroud gives
total air seal even between the fans!!, no
loss air as with other designs.
- Pre-punched shroud holes
for perfect hole alignment!
- Radiator can run up to 2
x 92mm fans in push / pull config or one side
of shroud can be used for mounting.
- 13mm shroud standoff to
minimise dead zone.
- Unique silver soldered bleed
inserts for bleeding off collected air &
maintaining performance.
- Overall dimensions HxWxD
= 150x109x60mm.
- Radiatior ships with single
side fan screws & a spare bleed washer.
- Capable of dissipating 150W
of heat at a 10°C coolant / air differential,
more if differential is increased.
- 0.070°C/W
|
| 
|
PRODUCT
UPDATE! (5/3/04)
One of the most
frequently asked questions regarding the HE90
series was "Why wasn't it made to fit
straight into a Chieftec Full Tower case as
the two are ideally suited?!"
The HE90.1 is
now available premodified especially for these
cases and all others with similar layouts (92mm
Exhaust above ATX PSU), which means these cases
can now be easily watercooled without ANY modifications
being necessary.
The clickable
thumbnails to the left and right show
closeup shots of the modified HE90.1 fitted
in a Chieftec Scorpio Full Tower (TA-10 Series),
however the mods will allow the radiator's use
in any of their full tower cases.
The mod also
ensures that a 2mm clearance gap is left between
the radiator and the ATX PSU to reduce thermal
conduction between the two, which could potential
decrease your cooling performance.
Remember to check
with your retailer whether their stock is the
new modified version (denoted by 8 mounting
holes in the shroud on the reverse side of the
radiator as opposed to the usual 4) if you will
be using your HE90.1 for this application.
Full Kits designed
for this range of cases based around the new
modified series are available right now from
Over-Clock
UK (O-CuK Thermatic Kit) |
|
HE120.1
// HE120.2 // HE120.3
// HE80.1 // HE80.2
// HE90.2 // ThermoTube
// PA160 // PS120.x
|
