DISCONTINUED

HE Series - Optimised for Fans with an individual CFM Output of 100CFM or More

• ThermoChill HE120.3 high performance Heat Exchanger. The King of cool!!!!


Rev3 - No longer requires individual shrouds per fan - fan mounts now integral to the radiator sidewalls.


• Copper / brass construction with turn coat shrouds.
• 3/8" BSPP (G3/8) inserts to allow the radiator to be used with any existing bore setup. e.g. 3/8"OD & ID, 1/2"OD & ID etc. Appropriate fittings will be available elsewhere on our website.
• Unique dual fan shroud & gasket cobination gives total air seal, no loss air as with other designs.
• Pre-punched fan holes for perfect fan alignment!
• Radiator can run up to 6 x 120mm fans in push / pull config or one side of shroud can be used for mounting.
• 10mm shroud standoff to minimize dead zone.
• Unique silver soldered bleed inserts for bleeding off collected air & maintaining performance.
• Overall dimensions HxWxD = 419x126x50mm..
• Radiatior ships with single side fan screws, a spare bleed washer, and neoprene sealing gasket to provide airtight seal of fan to rad.
• Capable of dissipating 550W of heat at a 10°C coolant / air differential, more if differential is increased.
• 0.015°C/W
  

• The defined rating conditions are:

  10°C coolant / air differential
  3.8 lpm (1.0 gpm) coolant flow rate, and
  a high performance fan (or fans, mounted on one side only).