Shown below with PS120.2
shroud fitted
|
DISCONTINUED
HE Series - Optimised for Fans with an
individual CFM Output of 100CFM or More
Rev3 - No longer requires
individual shrouds per fan - fan mounts now
integral to the radiator sidewalls.
Copper / brass construction with turn
coat shrouds.
3/8" BSPP (G3/8) inserts to allow the radiator
to be used with any existing bore setup. e.g.
3/8"OD & ID, 1/2"OD & ID etc. Appropriate fittings
will be available elsewhere on our website.
Unique dual fan shroud & gasket cobination
gives total air seal, no loss air as with other
designs.
Pre-punched fan holes for perfect fan
alignment!
- Radiator can run up to 4
x 120mm fans in push / pull config or one
side of shroud can be used for mounting.
- 10mm shroud standoff to
minimize dead zone.
- Unique silver soldered bleed
inserts for bleeding off collected air &
maintaining performance.
- Overall dimensions HxWxD
= 297x125x50mm.
- Radiatior ships with single
side fan screws, a spare bleed washer, and
neoprene sealing gasket to provide airtight
seal of fan to rad.
- Capable of dissipating 400W
of heat at a 10°C coolant / air differential,
more if differential is increased.
- 0.024°C/W
|
HE120.1
// HE120.3 // HE80.1
// HE80.2 // HE90.1
// HE90.2 // ThermoTube
// PA160 //
PS120.x
|
