Shown below with PS120.1
Shroud fitted
|
DISCONTINUED
HE Series - Optimised for Fans with an
individual CFM Output of 100CFM or More
Rev3 - No longer requires
individual shrouds per fan - fan mounts now
integral to the radiator sidewalls.
Copper / brass construction
with turn coat shrouds.
3/8" BSPP (G3/8) inserts to allow
the radiator to be used with any existing bore
setup. e.g. 3/8"OD & ID, 1/2"OD & ID etc. Appropriate
fittings will be available elsewhere on our
website.
Unique dual fan shroud
& gasket cobination gives total air seal, no
loss air as with other designs.
Pre-punched fan holes for
perfect fan alignment!
- Radiator can run 2 x 120mm
fans in push / pull config or one side of
shroud can be used for mounting.
- 9mm shroud standoff to minimize
dead zone.
- Unique silver soldered bleed
inserts for bleeding off collected air &
maintaining performance.
- Overall dimensions HxWxD
= 172x124x50mm.
- Radiatior ships with single
side fan screws, a spare bleed washer, and
neoprene sealing gasket to provide airtight
seal of fan to rad.
- Capable of dissipating 250W
of heat at a 10°C coolant / air differential,
more if differential is increased.
- 0.039°C/W
|
HE120.2
// HE120.3 // HE80.1
// HE80.2 // HE90.1
// HE90.2 // ThermoTube
// PA160 // PS120.x
|
